Introduction
This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-Vybrid System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
Versioning
This Release is compatible with the following hardware:
| BSP Release Version | BSP Release Date | SOM PCB Version | Cosmic Board PCB Version |
|---|---|---|---|
| PD13.1.0 | 8/30/2013 | 1374.0 | 1393.1 |
BSP Download
Release PD13.1.0 can be downloaded from the links below:
- PD13.1.0 MCC Demo including the pingpong demo (Cosmic+ only)
LinuxLink | PHYTEC FTP
- PD13.1.0 Small Footprint
LinuxLink | PHYTEC FTP
Quickstart
Release PD13.1.0 should be used in conjunction with Quickstart version QS1.0:
What’s Supported
This BSP Release supports the following components:
- Linux Kernel: 3.0
- NAND Flash: U-Boot
- UART: RS-232 via SCI_1
- USB: USB_0 in Device Mode (default virtual Ethernet); USB_1 in Host Mode
- SD/MMC: MMC via MCU_PTA24-29 signals
- Ethernet: 10/100 Mbit/s - ETH1 on RMII1
- RTC: Internal RTC
- SPI: QSPI_A; QSPI_B
- I2C driver: I2C_2 enabled
- PMIC
- Display: HDMI[1]
- Watchdog
What’s Not Supported
This BSP Release does not support the following components:
- CAN: CAN_0; CAN_1
- RTC: RV-4162-C7 on I2C_2
- High Speed Timer
- Power Management: Suspend to RAM
- MCC: Cortex-A5 (Linux) and Cortex-M4 (MQX)
Fixed in this Release
N/A
New in this Release
N/A
Known Issues
- [1] HDMI
Only works on some monitors.
Upgrade and Compatibility Information
To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.
Dependencies
N/A
Validation Information
Drivers have been tested with in-house test cases.
Technical Support
For further support please visit PHYTEC's Support Portal