Introduction
This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-Vybrid System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
Versioning
This Release is compatible with the following hardware:
| BSP Release Version | BSP Release Date | SOM PCB Version | CB PCB Version |
|---|---|---|---|
| PD13.0.0alpha | 1/25/2013 | 1374.0 | 1375.2 |
BSP Download
Release PD13.0.0alpha can be downloaded from the link below.
<ftp_link>
Quickstart
Release PD13.0.0alpha should be used in conjunction with Quickstart version PD13.0.2:
What’s Supported
This BSP Release supports the following components:
- U-Boot: boot modes - SD/MMC, TFTP
- Linux Kernel: 3.0
- UART: RS-232 via SCI_1
- SD/MMC: MMC via MCU_PTA24-29 signals
- Ethernet: RMII0
- RTC: Internal RTC
- I2C driver: I2C_2 enabled
- EEPROM: at24 on I2C_2
- TSC: STMPE811 on I2C_2
- Display: Prime View PD070WL4 LVDS
What’s Not Supported
This BSP Release does not support the following components:
- U-Boot: NAND; SPI-NOR boot mode
- UART: RS-232 via SCI_2
- Ethernet: RMII1
- SPI: SPI_A; SPI_B
- CAN: CAN_0; CAN_1
- USB: USB_0-OTG; USB_1-OTG
- Audio: Freescale Codec SGTL5000 connected to I2S (I2C_0)
- RTC: RV-4162-C7 on I2C_2
- Light Sensor: connected on I2C_2
- Timer: Watchdog; High Speed
- Power Management: Suspend to RAM
Fixed in this Release
N/A - First BSP Release
New in this Release
N/A - First BSP Release
Known Issues
N/A
Upgrade and Compatibility Information
To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.
Dependencies
N/A
Validation Information
Drivers have been tested with in-house test cases.
Technical Support
For further support please visit PHYTEC's Support Portal