Introduction
This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-OMAP44XX System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
Versioning
This Release is compatible with the following hardware:
| BSP Release | SOM PCB Version | CB PCB Version |
|---|---|---|
| PD12.1.0 | 1347.1 | 1348.2 |
| 1347.2 |
BSP Download
Release PD12.1.0 can be downloaded from the link below.
ftp://ftp.phytec.com/products/PCM-049_phyCORE-OMAP44xx/Linux/PD12.1.0/
Quickstart
Release PD12.1.0 should be used in conjunction with Quickstart version PD12.1.0:
What’s Supported
This BSP Release supports the following components:
- Serial Console
- NAND Flash
- Ethernet
- I2C
- USB Host
- USB Device
- Audio
- QT4.7
- Displays (PD104SLF, PM070WL4, PD050VL1)
- DVI
- SPI
- SD-Card
- Touch
- 4460
What’s Not Supported
This BSP Release does not support the following components:
- OpenGL
Fixed in this Release
N/A
New in this Release
N/A
Known Issues
- Display and DVI does not work when used parallel
- Touch gets sometimes wrong samples
- Audio: only mono for line out
- Nameserver configuration wrong
- 4460 usb otg: only device mode
Upgrade and Compatibility Information
To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.
Dependencies
N/A
Validation Information
Drivers have been tested with in-house test cases.
Technical Support
For further support please visit PHYTEC's Support Portal