Summary

The following guide provides instructions for connecting a display to PHYTEC phyBOARD SBCs. The phyBOARD-Segin (phyCORE-i.MX6UL) is used in this example but the instructions are applicable to other phyBOARD parts. 

Hardware Requirements

1. phyBOARD-Segin Kit (PB-02013) (or another suitable phyBOARD Kit)
2. PEB-AV-02 LCD Display Adapter
3. 40 pin FFC flex flat cable (PHYTEC Part # WF061)
4. 7'' EDT Display (PHYTEC Part # AC104)
5. AC power supply 12 V – 24 V DC/ min. 2.5 A
6. Serial Cable - RS232 (not pictured)

Software Requirements

• phyBOARD-Segin-i.MX6UL – PD17.1.1 Linux BSP

Setup

Download the BSP here and create a bootable SD card according to the steps in the Getting Started Guide.

...

Connect the host PC and phyBOARD-Segin assembly with the serial cable (use UART0 on PEB-EVAL-01 board) and insert power connector into mating connector as seen below.

Modifying the expansion board configuration file

The BSP is preconfigured to support various expansion boards, including the 7" display, and simply need to be enabled for use. Apply power to the device and monitor the serial output. When prompted, stop auto-boot by sending a character in the serial terminal.

...