...
- 2x phyBOARD-Mira SBC kits
- 2x PEB-WLBT-01 Expansion WiFi module
- 2x 12V power supplies
- 2x UART cables
<TODO: INSERT AN IMAGE OF THE HARDWARE HERE> (Make sure it shows the WiFi module plugged into the kit)
Step-by-Step Guide
...
| Code Block |
|---|
vi /etc/wpa_supplicant |
- Use the editor to make the following modifications to the file. Comment out the 'network' node and change the 'device_name' to something unique for each device. save and exit.
...
Choose one of the units to be the Group owner. The unit selected is referred to as phyBOARD-Mira #1 (Group Owner) in this guide. <TODO: INSERT AN IMAGE HERE> (Highlight phyBOARD-Mira #1 (Group Owner))
Follow the below commands to initiate the group. After setting up the group make sure to note the group owner MAC address and group pin because they will be needed to connect the second device.
...
The other phyBOARD-Mira can now to be used to connect to the established group. This unit is referred to as phyBOARD-Mira #2 in this guide.
<TODO: INSERT AN IMAGE HERE> (Highlight phyBOARD-Mira #2)
- Restart the wlan0 interface and assign an IP address. 192.168.3.11 is used in this example but this can be replaced with another value.
...