...
- phyCORE-AM5728 SOM (PCM-057)
- phyCORE-AM572x Carrier Board (PCM-948)
- Display. Recommended PHYTEC 7" capacitive touchscreen Display (LCD-018-070-KAP)
- 12V 2A Power supply with a barrel jack connector
- RS232 DB9 Serial Cable
- Bootable SD Card: Refer to the section 6 "Creating a Bootable SD Card" of the 18.1.0 quickstart to create an SD card.
- PHYTEC VM-009-M12 camera module (optional)
Step-by-step guide
Note |
---|
The instructions below assume you have setup the hardware per the Quickstart instructions, booted into Linux, and have serial console access. Refer to the Quickstart Guide for details on these steps. |
1. Connect the display to the RDK board. The display should be connected to the LCD power and data connectors at X25.
2. If you are using the PHYTEC VM-009-M12 camera module, install as described in the How-to: Test Camera on the phyCORE-AM57x Linux RDK guide.
3. Connect the 12V power supply, press the S2 switch to power on the board. After Linux boots enter 'root' as the user name to log in.
Code Block |
---|
PHYTEC: BSP-Yocto-TISDK-AM57xx-PD18.1.0 am5728-phycore-rdk login: root root@am5728-phycore-rdk:~# |
4. Execute the following commands to stop the TI Matrix GUI and Weston.
Code Block |
---|
root@am572x-phycore-rdk:~# /etc/init.d/matrix-gui-2.0 stop Stopping Matrix GUI application. root@am572x-phycore-rdk:~# /etc/init.d/weston stop Stopping Weston |
The GStreamer pipelines below implement various functions, as described5. Use the GStreamer pipeline examples below to test various functions. If you have installed a camera, use the 'Video Source' pipelines, otherwise the 'File Source' pipelines that use the pre-installed videos.
...