The PEB-D-RPI Expansion Board is designed to plug in to the phyBOARD-Zeta expansion interface and supports the 2x20 Raspberry Pi HAT header to facilitate rapid prototyping. The Raspberry Pi community has introduced a wide variety of add-on boards called HATs (Hardware Attached on Top). These readily available boards feature circuitry for LEDs, buttons, sensors, motors, displays, and more. By adding the PEB-D-RPI Expansion Board to your phyBOARD-Zeta you can leverage off-the-shelf add-on boards to accelerate the development cycle.
Documentation
How-To Guides
Pinout
The following diagram describes the 40-pin Raspberry Pi HAT pinout supported on the PEB-D-RPI Expansion Board.
Add-On Boards
There are a wide variety of add-on boards available on the market that will plug directly into the 2x20 Raspberry Pi header supported on the PEB-D-RPI Expansion Board.
PHYTEC is supporting the following RPI HATs in software:
PCB Design Files:
Related Articles
There is no content with the specified labels
Need Hardware?
Contact PHYTEC Sales to order hardware, learn about our product offering and capabilities, or for general questions. Call 800-278-9913 or send an email to sales@phytec.com
Getting more help
Need support? Visit the PHYTEC Service Desk for technical support, product questions, Return Merchandise Authorizations, and more!
News
Sign up for new product announcements.
Schematic Registration
Need schematics? Visit the PHYTEC Service Desk and register to receive schematics.
Note: Raspberry Pi is a trademark of the Raspberry Pi Foundation