Introduction
This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-i.MX35 System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
Versioning
Component | Version |
---|
Linux Kernel | 3.2 | Barebox | |
|
|
This Release is compatible with the following hardware:
BSP Release Version | BSP Release Date | SOM PCB Version | CB PCB Version |
---|
PD12.1.1 | December 14th, 2012 | 1315.6 | 1280.4 |
BSP Download
Release PD12.1.1 can be downloaded from the link below.
ftp://ftp.phytec.de/pub/Products/phyCORE-iMX350/Linux/PD12.1.1/
Quickstart
Release PD12.1.1 should be used in conjunction with Quickstart version l-724e:
What’s Supported
This BSP Release supports the following components:
- i.MX357
- Boot Modes: NAND Flash [1]; NOR Flash; SD Card
- Filesystem: UBIFS
- UART: UART1; UART3
- Ethernet: 10/100 Mbit/s
- SD/SDIO
- USB: USB Host - Memory devices, keyboard, mouse; USB Device - basic functionality
- CAN
- NAND Flash
- NOR Flash
- SPI driver
- I2C driver
- EEPROM: at24 on I2C1
- TSC: STMPE811 on I2C
- Display: 320 x 240
- Audio: Mixer, Line in, Line out, Mic-in
- One-wire
What’s Not Supported
This BSP Release does not support the following components:
- USB OTG HS / FS - Ethernet Gadget, Filestoring Gadget
- Camera Interface: MT9M001 (VM-006); MT9V022 (VM-007); MT9M131 (VM-009)
- Codecs: MPEG4 ENC/DEC
- Power Management: Suspend to RAM - Available upon request
- SDRAM Battery Buffered
Fixed in this Release
N/A
New in this Release
- Updated Barebox and Linux kernel
- UBIFS Filesystem
Known Issues
- [1] Due to a hardware issue, booting from NAND is not possible with PL 1315.6 and PCM 970. If you use a custom baseboard, make sure to set 2K-NAND i.MX35 Boot Configuration Pin or use eFuses to support booting from NAND.
Upgrade and Compatibility Information
To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.
Dependencies
N/A
Validation Information
Drivers have been tested with in-house test cases.
Technical Support
For further support please visit PHYTEC's Support Portal