|
This BSP provides a basis for development, deployment and execution of Compact 7 based applications on the phyCORE-AM335X System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
|
This Release is compatible with the following hardware:
BSP Release Version | SOM PCB Version | CB PCB Version |
---|---|---|
PD12.0.0alpha | 1358.2 | 1359.2 |
Release PD12.0.0alpha can be downloaded from the link below.
ftp://ftp.phytec.com/products/PCM-051_phyCORE-AM335x/Compact7/PD12.0.0alpha/
Release PD12.0.0alpha should be used in conjunction with Quickstart version PD12.0.0alpha:
This BSP Release supports the following components:
BSP components in the BSP and their current status if applicable:
OS Components included by default in OSDesign:
This BSP Release does not support the following components:
WiFi: TiWi R2 -- MMC2Bluetooth: TiWi R2 -- McASP1/UART1Audio: Line In, Line Out, Mic In, SpeakersI2C: EEPROMSPI: EEPROM, General purposeCAN
N/A - This is the first Release of this BSP
N/A - This is the first Release of this BSP
Workaround: Generate a different boot.cfg with the desired default settings
Workaround: Use static IP addresses
To upgrade to a new BSP release, use the Windows uninstaller to remove the existing BSP via Start->Control Panel->Uninstall a program. Then install the new BSP using the Microsoft installer package or executable, e.g., Phytec_AM335x_Compact7_Setup-PD12.0.0alpha.exe.
N/A
Drivers have been tested with a combination of in-house test cases, as well as with the Windows Embedded Compact7 Test Kit (installed along with Windows Compact 7) where applicable.
For further information or to report any problems, contact PHYTEC Technical Support.