This BSP provides a basis for development, deployment and execution of Linux based applications on the phyFLEX-i.MX6 System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
This Release is compatible with the following hardware:
|BSP Release Version||BSP Release Date||SOM PCB Version||FLEX Mapper Board Version||FLEX Baseboard Version|
|PD14.1.0_EA1||July 14th, 2014||1362.2||1367.3||1364.4|
|1362.1||1367.2 [A]||1364.3 [B]|
|1367.1 [B]||1364.2 [A]|
[A] Does not fully support PCIe. FLEX Mapper board does not include nPCIe0_PERST. FLEX Baseboard missing 100Ω termination resistor on PCIe clock and reset for an extra PCIe.[B] Hardware interface does not support Camera0 interface extension and full 18-bit Camera0 (missing J6 and J7 for CSI0_DAT3 and CSI0_DAT2 signal multiplexing). Different reset out circuitry for Camera0 and Camera1. JP12 does not exist (X_CAMERA1_CLK & X_CAMERA0_CLK).
Release PD14.1.0_EA1_Yocto can be downloaded from the link below.
There are a wide variety of configurations (Quad/DualLite/Solo, RAM sizes, and WiFi) for the phyFLEX-i.MX6 SOM. Please note that there are different versions of software for each configuration.
Current support is available for the i.MX6 Quad with 1 GB, 1 bank of RAM. Additional configurations are targeted to be supported in the next BSP release.
Release PD14.1.0_EA1_Yocto should be used in conjunction with Quickstart version PD14.1.0_EA1_Yocto:
This BSP Release supports the following components:
Quad: 1GB, 1GB_1bank, 4GB
Resistive: STMPE811 on I2C0 (device on Baseboard)
Prime View PM070WL4 LVDS (LCD-017-070W)DVI / HDMI
Signal names may change between processor and PCBs. Please refer to phyFLEX-i.MX6 Hardware Manual for signal name mapping.
This BSP Release does not support the following components:
Prime View PD050VL1 LVDS (LCD-017-050V)Prime View PD104SLF LVDS (LCD-017-104S)EDT ETM0700G0DH6 TTL (LCD-018-070-KAP)
Workaround: Do not bring eth0 down while another interface is up (ex. wlan0).
Workaround: Use NFS-based root filesystem or sd-card based root filesystem.Required Fix: The MKUBIFS_ARGS setting must be configured to match how barebox is reading the partition, or the partition scheme itself is offset incorrectly.
This BSP is not backwards compatible and has no workaround for 1362.0 SOM and 1364.1 Baseboard due to a change in PCB pinout, see Modification of the pinout for the phyFLEX-i.MX6 (PLF-A-XL1).
Drivers have been tested with in-house test cases.
For further support please visit PHYTEC's Support Portal.