Introduction

This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-Vybrid System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.

Versioning

This Release is compatible with the following hardware:

BSP Download

Release PD13.1.0 can be downloaded from the links below:

• PD13.1.0 MCC Demo including the pingpong demo (Cosmic+ only)

LinuxLink | PHYTEC FTP

• PD13.1.0 Small Footprint

LinuxLink | PHYTEC FTP

Quickstart

Release PD13.1.0 should be used in conjunction with Quickstart version QS1.0:

• Cosmic_Board-Vybrid_Quickstart-QS1.0

What’s Supported

This BSP Release supports the following components:

• Linux Kernel: 3.0
• NAND Flash: U-Boot
• UART: RS-232 via SCI_1
• USB: USB_0 in Device Mode (default virtual Ethernet); USB_1 in Host Mode
• SD/MMC: MMC via MCU_PTA24-29 signals
• Ethernet: 10/100 Mbit/s - ETH1 on RMII1
• RTC: Internal RTC
• SPI: QSPI_A; QSPI_B
• I2C driver: I2C_2 enabled
• PMIC
• Display: HDMI^[1]
• Watchdog

What’s Not Supported

This BSP Release does not support the following components:

• CAN: CAN_0; CAN_1
• RTC: RV-4162-C7 on I2C_2
• High Speed Timer
• Power Management: Suspend to RAM
• MCC: Cortex-A5 (Linux) and Cortex-M4 (MQX)

Fixed in this Release

N/A

New in this Release

N/A

Known Issues

• ^[1] HDMI

Only works on some monitors.

Upgrade and Compatibility Information

To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.

Dependencies

N/A

Validation Information

Drivers have been tested with in-house test cases.

Technical Support

For further support please visit PHYTEC's Support Portal