Operating SystemLinux
BSP Release Status

RELEASED

Release Date

  

Repository 
Binariesftp://ftp.phytec.de/pub/Products/phyCORE-iMX350/Linux/PD12.1.1/
Source Archive 
Release Notes

Click Here


Introduction

This BSP provides a basis for development, deployment and execution of Linux based applications on the phyCORE-i.MX35 System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.

Versioning

ComponentVersion
Linux Kernel3.2
Barebox 
 

This Release is compatible with the following hardware:

BSP Release VersionBSP Release DateSOM PCB VersionCB PCB Version
PD12.1.1December 14th, 20121315.61280.4

BSP Download

Release PD12.1.1 can be downloaded from the link below.

ftp://ftp.phytec.de/pub/Products/phyCORE-iMX350/Linux/PD12.1.1/

Quickstart

Release PD12.1.1 should be used in conjunction with Quickstart version l-724e:

What’s Supported

This BSP Release supports the following components:

  • i.MX357
  • Boot Modes: NAND Flash [1]; NOR Flash; SD Card
  • Filesystem: UBIFS
  • UART: UART1; UART3
  • Ethernet: 10/100 Mbit/s
  • SD/SDIO
  • USB: USB Host - Memory devices, keyboard, mouse; USB Device - basic functionality
  • CAN
  • NAND Flash
  • NOR Flash
  • SPI driver
  • I2C driver
  • EEPROM: at24 on I2C1
  • TSC: STMPE811 on I2C
  • Display: 320 x 240
  • Audio: Mixer, Line in, Line out, Mic-in
  • One-wire

What’s Not Supported

This BSP Release does not support the following components:

  • USB OTG HS / FS - Ethernet Gadget, Filestoring Gadget
  • Camera Interface: MT9M001 (VM-006); MT9V022 (VM-007); MT9M131 (VM-009)
  • Codecs: MPEG4 ENC/DEC
  • Power Management: Suspend to RAM - Available upon request
  • SDRAM Battery Buffered

Fixed in this Release

N/A

New in this Release

  • Updated Barebox and Linux kernel
  • UBIFS Filesystem

Known Issues

  • [1] Due to a hardware issue, booting from NAND is not possible with PL 1315.6 and PCM 970. If you use a custom baseboard, make sure to set 2K-NAND i.MX35 Boot Configuration Pin or use eFuses to support booting from NAND.

Upgrade and Compatibility Information

To upgrade to a new BSP release, simply delete the old release and extract the new release in its place.

Dependencies

N/A

Validation Information

Drivers have been tested with in-house test cases.

Technical Support

For further support please visit PHYTEC's Support Portal