This software release is maintained by www.phytec.de.
Introduction
This BSP provides a basis for development, deployment and execution of Linux based applications on the i.MX6 System on Module (SOM). For detailed information on the various software components included in the release and how to use them, please refer to the Quickstart.
Versioning
Software
Supported Hardware
phyFLEX-i.MX6 SOM and Kit (Quad, DualLite, and Solo)
Single Board Computers:
phyBOARD-Mira (Quad, Quad Plus, DualLite, Solo)
phyBOARD-Subra
BSP Download
Prebuilt images of PD16.1.1 can be downloaded from the link below:
ftp://ftp.phytec.de/pub/Software/Linux/BSP-Yocto-i.MX6/BSP-Yocto-i.MX6-PD16.1.1/images/
Quickstart
Quickstarts for Yocto i.MX6: BSP Yocto i.MX6 Manual PD16.1.x
Fixed In This Release
Kernel
CAN is now working with 10 kbaud
A bug was fixed where the LVDS display sometimes did not show anything after boot. This bug is described in erratum ERR009219
Fixed a typo in the HDMI devicetree node which prevented DDC to work correctly.
The npwrdn GPIO assignement on the phytec-mediabus was fixed from GPIO5_27 to GPIO3_9 on the phyBOARD-Mira.
Fixed a bug described by erratum ERR007117 which led to an infrequent detection failure of the NAND flash during boot.
Fixed a GPU stability issue where the GPU clocks run on clock rates which were to high by default.
Fixed a stability issue when switching the internal LDOs of the i.MX 6DualLight into bypass mode.
Introduced small performance improvements by disabling spinlock debug logging which is enabled by default.
Barebox
Barebox devicetree now supports environment on SPI-NOR flash
Fixed the CS0_END RAM setting for the i.MX 6QuadPlus
Fixed a bug described by erratum ERR007117 which led to an infrequent detection failure of the NAND flash during boot.
Improved RAM timings for i.MX6 DualLite\Solo (400 MHz) on all phyFLEX machines.
New In This Release
Added support for ISSI and Winbond NOR flash
Winbond W25Q128
ISSI IS25LP128
Added support for Winbond NAND
Linux kernel upgraded to v4.1.46 (from v4.1.36)
Not Supported
N/A
Known Issues
PHYTEC Known Issues
- Kernel
- The LDB_DI0_SEL and LDB_DI1_SEL mux can only be set in the devicetree and cannot be changed on runtime
- QuadPlus:
- Display and HDMI do not work
Technical Support
For further information or to report any problems, visit the PHYTEC Support Portal